Installation of siding with their own hands

By Admin | The Hands
18 May 2016
to enjoy spending time Evgeniy72 family in 2007 bought six acres of land with an unfinished house.When buying a log cabin has been Hobbit paneling, flooring insulated with mineral wool, laid on top of a board of 50 mm.On the second floor, no one rafter finish, that's the whole interior of the purchased home.

Due to lack of money Evgeniy72 decided to finish building their own home.The house he was going to live only in the summer.

The construction

After buying the land he once engaged in repairing the house and the first thing straightened foundation.

The fact that the original strip foundation was poured just under the frame, but the two wings that were built later turned out to be without foundation.Therefore it was necessary to raise the frame, and extension and pour concrete.



then bought siding with the expectation to have enough on one floor, and proceeded to his installation.On the ground floor used Nordside.As he had planned, over the summer, he sheathed the first floor siding
.

In 2008 Evgeniy72 decided to sheathe siding second floor.There had to redo everything.Boards were nailed outside of the Christmas tree, he cut back to back, pulled windproof membrane Yutavek 85, filled strips of metal sheets, and they fixed the siding.

Then he purchased lumber and insulation and started warming and finishing the second floor inside.For insulation Isover mineral wool used in plates of 10 cm. After warming the house warms up quickly and become a good to keep warm.

Evgeniy72 made installation of siding on the technology of ventilated facades, using wind-water-proof membrane, which promotes evaporation of moisture from the insulation.



siding on the house all fixed the screws with a flat cap 19 mm.As stated in the installation manual, screws not dokruchival.Time has shown that the screws hold well.



purchased materials and the cost for the installation of insulation and siding of the first floor (63 square meters 3 sides, 2007)
  • Vetro-water-proof membrane "Megaizol A" roll of 50 sq.m.- 1200rubley;
  • Insulation - Isover KL-37-100 610 1170h610h100, 8 pieces of 800rubley - 6400rubley;
  • Suspension direct 60h27, 150 pieces of 3 rubles - 450 rubles;
  • Metaloprofil 60h27, 30 pieces of 30 rubles - 900 rubles;
  • Siding Nordside 3,85h0,231metra cream-colored 77 pieces of 120 rubles - 9240 rubles;
  • Self "bugs" 4,2h25mm, 500 pieces - 200 rubles;
  • Self 3,5h51mm black, 500 pieces - 100 rubles;
  • boards 50h25h6000 25 pieces 25h48 rubles - 1200 rubles;
  • Rake finishing 3.85 meters, 5 pieces of 110 rubles - 550 rubles;
  • Home rake 3.85 m, 6 pieces of 85rubley - 510 rubles;
  • J-profile 3.85 meters, 8 pieces of 120 rubles - 960 rubles;
  • Spotlights perforated 3,85h0,254metra white, 6 pieces of 240rubley - 1440 rubles;
  • Rake - casing 3.85 m, 5 pieces of 275rub - 1375 rubles;
  • outer angle of 3.05 meters, 2 pieces of 310 rubles - 620 rubles;
  • internal angle of 3.05 meters, 8 pieces of 230 rubles - 1840 rubles;
  • sheet of galvanized iron on low tides - 300 rubles.
Total spent - 27 285rubley .



siding installation 2 floors (52 sqm - 2008year)
  • Canadian siding "Mitten" 3,66h0,23, 66 pieces of 135 rubles - 8910 rubles;
  • Vetro-water-proof membrane Yutavek - 1800 rubles;
  • Black screws 3,5h51mm, 500 pieces - 100 rubles;
  • Self "bugs" 4,2h25 mm, 500 pieces - 200 rubles;
  • J-profile Nordside 3,85metra, 16 pieces of 125 rubles - 2000 rubles;
  • Metaloprofil 60h27, 60 pieces of 30 rubles - 1800 rubles;
  • outer angle of 3.05 meters, 2 pieces of 340 rubles - 680 rubles;
  • Home rake Nordside 3,85 m 6 pieces of 105 rubles - 630 rubles;
  • Molding Dёke 3 meters, 12 pieces of 150 rubles - 1800 rubles;
  • Spotlights perforated white 3,85h0,254 meters, 8 pieces of 280 rubles - 2240 rubles.
Total spent - 20 160rubley.


Posted party forum "Home and cottage" Evgeniy72
Editor: Roman Adamov